Warm window installation: what it is and why it matters more than the profile

Sometimes an expensive new window starts letting in draughts around the edges after just a couple of winters, and the reveals become covered in condensation and mould. The culprit is almost never the profile but the installation joint. Here we explain what warm installation is and why it matters.

The three layers of the installation joint

A proper joint between the frame and the wall consists of three layers. This scheme is required by both European standards and the Ukrainian DSTU.

  1. Inner layer — vapour barrier. A tape on the room side keeps warm, moist air out of the foam.
  2. Central layer — insulation. Expanding foam fills the gap and retains heat.
  3. Outer layer — diffusion tape. It protects the foam from rain and UV radiation but lets moisture escape outside.

The principle of “tighter on the inside than on the outside” keeps the joint dry. With standard installation, the foam is simply trimmed and plastered over — and over time it absorbs moisture, crumbles and stops insulating.

Typical installation mistakes

  • The foam is not protected on the outside and breaks down in the sun within 1–2 years.
  • The joint is too wide (more than 40–50 mm) because of inaccurate measurement.
  • The window is not set level, so the sashes rub and don't seal properly.
  • The fixings are spaced too far apart, and the frame “plays”.
  • There is no sealing under the external sill, so water gets into the joint.

How much warm installation costs

According to Kyiv price lists for 2026, standard installation costs on average 570–600 UAH/m², while warm installation with tapes costs about 1,000 UAH/m². For a 1300×1450 mm window the difference is roughly 750 UAH. The money pays for itself: the joint lasts as long as the window itself.

When warm installation is a must

  • Detached houses and top floors.
  • Corner rooms and windows on the windward side.
  • If you are fitting the warm Softline 82 profile or an energy-saving glazing unit — otherwise their advantage will be lost in the joint.

You can choose the type of installation right in the window calculator, and find out more about how we work on the “Delivery and installation” page.

← All news and articles